Magnet Door Handle for Standard Voron 2.4 Frame with 3mm single door and 3mm sealing tape.
Installation requires drilling - works only with acrylic glass not plexi(C)-glass. Check yours!
What to print:
- 2x Door Latch
- 1x Door Handle
BOM:
- 2x M3x8 BHCS
- 2x M3x6 BHCS
- 2x M3 shim
- 4x 6x3 magnets (N52)
- 2x M3x5x4 heat-set insert
- 2 M3 t-nuts
- 2 M4 drill
Installation:
- Drop in M3 t-nuts where the handle should be
- Insert magnets in door latch (without glue) and screw tight with M3x8 BHCS.
- Insert heat-set insert into handle (small holes)
- Super glue the magnets into the handle (mind polarity) - don't worry the latch-magnets can be changed easily
- Align everything so the door is shut and everything is flush
- Mark the door-panel from inside where the heat-set insert are
- Gently drill both holes (check if your panel is suited for drilling!)
- Secure handle with M3x6 BHCS and M3 shim.