Cable holder for IKEA BEKANT table where only the cable holder is visible from above and no glue or penetrating screws are involved. Not perfect, but works.
Printer:
Bambulabs A1 mini
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
15%
Filament:
eSun PLA+, white
Instructions
1. Connect the two pieces (I used a pipe wrench and sth. to protect the surface)
2. Loosen IKEA BEKANT side screw 1-3mm
3. Slide the cable holder over the screw
4. Fasten the screw again