Christmas Movie Themed Coasters by TazzPB

TazzPB

Household>Decor

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

5 h

2 plates

5.0(2)

Boost

Released

Description

Share your love for Christmas movies with these awesome coasters! Just change the colours to suit your Christmas colour scheme, and yippee-ki-yay, you're good to go!

These are printed face down, with 5 bottom layers. I print them with 1.02 flow rate, just slightly lower than you'd need for a lightbox.

The coaster holder will fit 4 coasters with cork backing applied to them. I used these, and they work perfectly! The coaster holder can be printed in one colour, or 3 separate colours. Just change what you need to in the object settings!

I hope you all enjoy these!

Comment & Rating (5)

@itsrichard485

Print Profile

0.2mm layer, 2 walls, 15% infill

came out great!

The designer has replied

@TazzPB

Thank you for the feedback! Yours look great!!

@jtempkin

My p1p is really struggling with these. the project seems to get hung up in the inital lettering and snagging the print off the plate. Can you explain some of the settings logic? (like the fuzzy and no cooling?

The designer has replied

@TazzPB

I don't run aux cooling with PLA on the heated bed as it can cause lift. Also, I don't use fuzzy skin. Up your flow rate slightly from the standard to make sure it fills in the gaps, and use arachne walls. Are you using the profile I uploaded? :)