Voronoi Squirrel Remixed by mkersjes

Remixed by

mkersjes

Art>Other Art Models

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.16mm layer, 2 walls, 15% infill

Designer

4.3 h

1 plate

4.4(5)

0.16mm layer, 2 walls, 15% infill

Designer

4 h

1 plate

Boost

Released

Description

I made this Voronoi squirrel but had to place a small pin to keep it standing upright because it is tail heavy..

Comment & Rating (11)

@Squirrelly_J

Print Profile

0.16mm layer, 2 walls, 15% infill

Printed fine. The print is back heavy and will not stand without a peg. The model has the peg included, but it snaps off very easy like a support. I think I am going to just make a base to glue it onto. I like the way the print looks.

The designer has replied

@mkersjes

many thanks for the feedback , I will try to change it so it will snap less likely off with the support.

@phinal

Print Profile

0.16mm layer, 2 walls, 15% infill

Very cute. Just a little back heavy. But nothing a base and a little bit of glue won’t fix.

The designer has replied

@mkersjes

thanks for the feedback, it is indeed back heavy hence the pin under the tail.. but it should stand upright on a normal hard surface.

@snm.grr

Replying to @mkersjes :

for sure does not when printed with silk copper PLA. I don't if something came off with the supports, but it looks totally fine, just sits on the tail :)

@snm.grr

Print Profile

0.16mm layer, 2 walls, 15% infill

Too tail heavy, won't stand, but is still super cute on it's back legs :D Printed on Bambu A1, printed without any issues in copper silk.

The designer has replied

@mkersjes

there should be a small pin.

(Edited)