Oh Fudge Keychain by Bearded Dad Designz

Bearded Dad Designz

Fashion>Other Fashion Models

Print Profile(3)

All

X1 Carbon

P1S

P1P

X1E

0.12mm layer, 3 walls, 100% infill

Designer

49 min

1 plate

4.8(12)

Single Magnet Version

51 min

1 plate

Multiple Magnet Version

6.7 h

1 plate

Boost

Released

Description

Keychain inspired by a classic movie. This can be a keychain or even an ornament for a tree.

Comment & Rating (16)

@CraftyEnelrad

Been busy printing for the season. So many cute Christmas themed prints. These keychains were at the top of my list. Printed 16 of each of them. I maxed out my BL Carbon X1 bed. All came out beautifully. I also remixed the print to include a 20x3 magnet and printed 16 of these as well. Can't wait to give them out as little presents. Thanks for the awesome print.

(Edited)

The designer has replied

@BeardedDadDesig

came out awesome!!! what filment did you use gingerbread?

@CraftyEnelrad

Replying to @BeardedDadDesig :

For all these prints I used the following filaments: Matte Brick Red - Overture - PLA White - Inland - PLA+ Black - Inland - PLA+ Chocolate - Ziro 3D Filament - Matte PLA I printed them face down on a "non-specific" textured plate using no glue and just an IPA cleaning between prints. JIK of smudgy finger print from removing the previous prints. I think it gives the prints a wonderful fuzzy appearance.

@WagZPrintZ

Print Profile

0.12mm layer, 3 walls, 100% infill

print came out great. colored as needed and placed face down. went fine for me! i also scaled it up to max bed plate size and bingo! i made final print 1mm thick! thank you!!