Dragon's Tale Bookmark
Boost
202
359
91
Print Profile(3)
with ironing! 0.2mm layer, 3 walls, 20% infill
Designer
26 min
1 plate
without ironing! 0.2mm layer, 3 walls, 20% infill
Designer
16 min
1 plate
0.16mm layer, 3 walls, 15% infill
17 min
1 plate
Boost
202
359
91
9
565
702
Released
Description
Celebrate the Year of the Dragon with this enchanting Dragon's Tale Bookmark. Simple in design yet full of charm, this bookmark captures the essence of the majestic dragon in a sleek silhouette. Perfect for dragon lovers and avid readers alike, it's a delightful companion for your literary adventures. Whether you're exploring fantastical realms or journeying through historical epics, let this bookmark be your guide, holding your place and bringing a touch of mythical magic to your reading experience.
I added a print profile without ironing, but i recommend the version with ironing, since it came out great!
Check out my Loveball Twist Lock Container!
Comment & Rating (91)
All
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
quick print and looks great!
(Edited)
The designer has replied
1
Reply
love it! I can’t decide if the ironed or the textured side look better. both good choices! thanks for sharing!
0
Reply
Print Profile
without ironing! 0.2mm layer, 3 walls, 20% infill
very cool file. printed very nice.
The designer has replied
1
Reply
thanks for the make! looks good in red!
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
No issues lovely quick little bookmark :)
0
Reply
Print Profile
without ironing! 0.2mm layer, 3 walls, 20% infill
such a cool book mark! thanks!
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
I made the bookmark smaller.
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
I had a few failed attempts before getting this one. looks really cool. I printed this on dual silk PLA
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
for my son. he loved it.
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
I printed 3 of those little dragon bookmarks at once, it saved me some time compared to individual printing. They turned out perfectly and I am very happy with them, my friends love them as well. Thank you for sharing this cute design.
(Edited)
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
quite thin, I believe this will break very easily. other than that it printed well and looks good. The nose hole is also too small, so its barely visible, looks more like a print defect than an intentional detail.
Strength Issue
0
Reply
Print Profile
with ironing! 0.2mm layer, 3 walls, 20% infill
Quick and easy print. I would be careful on books with thinner pages, with the circle cutouts they are more flexible but provide a bit more area to dig at the page.
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld