Karlsruher SC Logo Table Stand
Copyright Claim
Karlsruher SC Logo Table Stand
Boost
1
4
2
Print Profile(1)
0.2mm layer, 2 walls, 10% infill
Designer
1.5 h
1 plate
Boost
1
4
2
0
18
16
Released
Description
Karlsruher SC Logo
- Hinweis / Notice:
- Sollte dein Modell wackeln, versuch etwas mehr Infill im Boden / Standfuß…
- Should your model wobble, try a little more infill in the bottom…
Please rate my print profiles / models... ♥
Bitte bewertet meine Druckprofile / Modelle... ♥
Comment & Rating (2)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
the only thing i did was adding 80% infill in the bottom 1/3 of the model so it has a better stand and does not tip over as easy
(Edited)1
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld