A simple whistle, small but fully functional
Boost
9
9
7
Print Profile(2)
supports only under the handle_0.24mm layer, 15% infill
Designer
20 min
1 plate
Simple whistle_0.24mm layer, 2 walls, 15% infill
Designer
26 min
1 plate
Boost
9
9
7
2
18
15
Released
Description
A simple whistle, small but fully functional
I made a small but fully functional whistle for a friend who coaches a football team
Small amount of filament, only 4g
The supports are also inside the whistle. I use a stronger needle or a micro screwdriver to remove it.
On the second printing profile, the supports are only under the ring, the whistle is turned.
Comment & Rating (7)
All
Print Profile
Simple whistle_0.24mm layer, 2 walls, 15% infill
can confirm this works. supports need some work. but nothing a good sharp knife won’t take care of.
The designer has replied
1
Reply
Thank you for the rating, photo and feedback.
I used a stronger sewing needle for the supports.
I tried twisting the whistle and using supports only under the ring, also functional.
0
Reply
Print Profile
supports only under the handle_0.24mm layer, 15% infill
ok
0
Reply
Print Profile
supports only under the handle_0.24mm layer, 15% infill
Věry good
0
Reply
Boosted
Print Profile
supports only under the handle_0.24mm layer, 15% infill
good
0
Reply
Print Profile
supports only under the handle_0.24mm layer, 15% infill
Very loud
0
Reply
Boosted
Print Profile
supports only under the handle_0.24mm layer, 15% infill
Very good. Very loud whistle
(Edited)
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld