Low poly Xi'an JH-7A Flying Leopard (NATO reporting name 'Flounder') in clean configuration and without landing gear.

The scale is 1:144.

Prints in a single piece with supports, but without an excessive amount of them.

**Print nose up at a 45 degree angle with tree supports.** The supports will only attach to the trailing edge of the wings, elevators, vertical stabilizer, ventral fins, and engine nozzles, so it won't look as bad as you think! **If your slicer of choice doesn't add them automatically, paint them on**

I am definitely going to make a future update with payload and landing gear options. I already modeled many weapons, pods, bags, and pylons, but I can't get them to print well yet and I haven't made the final decision on how they should be attached.

As of this posting I have only uploaded the F-16A and JH-7A models, but I already finished and printed F-4E Phantom, MiG-21bis, J-7E, Mirage III, Super Etendard, F-15A/C, and MiG-25P/PD, as well as modeling but not yet printed even more. The others are not up yet because I have to do further testing so they can print reliably with minimal support scarring (The MiG-25 elevators are easy to wreck when removing supports, for example).

The print orientation was a bit troublesome to develop, let me know if it causes problems for you.