Collar Stays for Dress Shirts - Includes 4 Sizes
Boost
3
10
2
Print Profile(3)
PETG, 0.2mm layer, 6 walls, 25% infill
Designer
59 min
5 plates
PLA, 0.2mm layer, 6 walls, 25% infill
Designer
59 min
5 plates
PETG, IRONING, 0.2mm layer, 6 walls, 25% infill
Designer
1.5 h
5 plates
Boost
3
10
2
0
2
3
Released
Description
Keep your shirt collar stiff with these 3D printed collar stays.
HIGHLY RECOMMENDED to print with PETG!
4 sizes are included: 2.2”, 2.35", 2.5", 2.75"
A set of (2) collar stays takes roughly 10 minutes to print.
There are two extra print profiles:
- PETG with ironing for a smoother top layer.
- PLA. Not recommended, as PLA printed this thin will break after some time.
Comment & Rating (2)
All
Print Profile
PETG, 0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
PLA, 0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld