Numbers Puzzle (PVA Tolerance Print Test)
Copyright Claim
Numbers Puzzle (PVA Tolerance Print Test)
Boost
0
0
2
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
2.1 h
1 plate
Boost
0
0
2
0
5
2
Released
Description
This is a print in place puzzle game I designed to test the tolerance of PVA prints.
With this I could verify that a single 0.2mm PVA layer is enough to separate the game pieces by soaking them over night.
Comment & Rating (2)
All
I printed it using Bambu Labs new PVA filament. It took about 1 week of soaking in water, moving a few pieces everyday and changing out the water, until water was able to get under all of the tiles and they all were movable. Very cool design and test for the new PVA filament. Thank You
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld