This is an absolutely gorgeous high quality replica weapon which was ceated by Punished Props about 6 years ago, but it was a lot of work to print and paint and had issues with the handle fitment. I've remastered this to be a fully painted AMS print with a vertical extremely high quality print and a horizontal split print which halves the time by halving the model. I did some assembly where it suited and optimized each print for the best quality with the least amount of color changes.

This was printed in eSun Red, Black, Cold White and a generic silver (eSun silver tends to be quite dull and basically grey).

When I was done with the Thirst Zapper, I got to work remixing my nuka cola clock to create a wall mount for display. This is available in two versions to have the zapper pointing to either the left or right (named left or right accordingly). If you'd like to check out the clock you can find it here https://makerworld.com/en/models/79776

Assembly instructions - The Horizontal (split) print will need to be dowelled and glued together - just use the photo for reference and you'll be fine. The only part which is a little tricky is the handle - be sure and use a minimal amount of glue and get these two pieces to connect with no gap and as perfect as possible.

HANDLE ASSEMBLY

To attach the handle, you will need to insert it into the body trigger first, if the trigger isn't fitting into the hole . Push the trigger in as far forward and into the body as possible and the handle should be able to be positioned to almost fit into the hole. From there, apply pressure until it snaps into place. If you are unable to do this, find someone to help.

I hope you love this as much as I do, and if you do, please like follow and give us a review!