Corner Clamp - No Supports Remixed by Maks3D

Remixed by

Maks3D

Education>Engineering

Print Profile(1)

All

0.2mm layer, 3 walls, 20% infill

Designer

8.3 h

4 plates

4.8(6)

Boost

108

125

Released

Description

Small variant for materials up to 1 inch / 26mm - Large for sizes up to 1.75 inch / 45mm

Print with the base and screw block flat on the base, with the screw vertical.

Doing it this way no supports are needed, and the threads will print fine.

Strength comes from the walls so use at least 3, and 20% infill in Gyroid.

Printed in PLA+. Recommend using PETG or ASA, or even better Nylon if you have access to it.

Before first use I recommend winding the thread all the way in and out once to clean up the threads.

Adding a dab of silicone grease will make the whole assembly a bit smoother.

Comment & Rating (13)

@jayusmc

hi.. i tried to print twice different days separated by many days of printing with a bambu p1s .04 nozzle this is what i got..the worst print ever,missing corners walls, zoom in.you should check the files...thanks anyway...

The designer has replied

@makstomalak

Sorry to see you have had troubles. I have checked the files and there have been many successful prints. Looks like you are having filament issues, maybe too wet/old? Printing too fast or too hot for your filament can also cause issues like stringing or blobbing.

@SevenxMinutes

Boosted

Print Profile

0.2mm layer, 3 walls, 20% infill

super sturdy and very helpful. adding some silicone grease to the screw helped, since without it I was having trouble getting things tight without them moving on me. the parts I was clamping were super thin though.