Suitable for filaments weighing 3 kilograms or filaments with a diameter of 250mm. Effectively prevent the filament from getting damp.
Large models have edge warping issues:
A groove was opened at the bottom and patches were added at the four corners to increase tension and prevent warping. Immediately remove the model when printing is completed, rinse the outer side of the bottom with water, which can quickly cool down and release stress, achieving perfect non warping.
Wishing you a pleasant printing experience.
The required accessories are at the end.
All of the above are machine translations.
Required:
608 bearing, 4 pieces
5X3 magnet, 6 pieces
M2.5x8 screw, 4 pieces
M2.5x3.5x5 hot melt nut, 4 pieces
CL267 Damping hinge, 1 pieces