This is a weekend project I took upon myself when a friend of mine gave me a coffee mug neatly broken in half and said "do some 3D printing stuff with it".
The design is for a mug with a diameter of about 9-10cm, I did some half-assed measurements but it worked on the first try so I hope this will work for others as well.
This might also be practical for a mug that's not broken, by using the handle to get the cookies out.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.28
Infill:
30%
Filament:
unknown PLA
Notes:
Should be printed with the handle (the stick with the loop at the end) touching the bed, for minimal supports.
The resolution is pretty bad but it was good enough for me, you can adjust according to your needs.