This is a simple and clean tape dispenser. This is designed with a slot and catch system to hold the two sides together.

This uses a piece of aluminum foil cutting strip. There is a slot in the model to help cut the right size.

After cutting use the slot to bend the blade 90° which makes it the perfect size to be glued to the frame to have the blade stick out just enough to cut nicely without sticking out too far.

Recommended settings

• 2 wall layers
• I have not tested more than .2 layer height but .2 to .12 seemed to have worked well on my printer.
• PLA worked well for me but PETG may last longer.
• No supports