Description

Photo Box Customizable with Magnets

Very customizable to meet your needs! You are only Limited by your imagination. 1 x 1 x1, 1x2x1, 2x2x2, etc.

I connected a strip of LED lights to magnets that can attach to the Pannels. This allows me to move around the lights as I need.

Parts

Magnet holes are 6 mm x 3 mm

These are what I use. 100 for less than $8 usd.

Pay extra special attention when placing the magnets. All panel magnets need to face the same way and opposite of the connectors.

Most holes are super tight and will not need glue for the magnets, but some may. As mine did.

STL's

There is 4 STL's uploaded.

Bottom panel - (Could be used as a Top as well). The bottom panels are 200 X 205. The bottom of the panel as well as the back of the panel is labeled with a “B”. This side is longer to allow the magnets to line up. Place all side panels on top of bottom panels.

Side panels - 200 x 200. This can be used as the sides as well as any bottoms that do not use 2 or more side panels.

Straight connector - to attach panels or bottom that is side by side.

90 Degree Connector - L shaped. One side is longer than the other. Attach appropriately.

I do have plans to upload other panels. Half panels, Light panels, Etc.

Commercial license

As of 2/25/24 my designs are no longer allowed to be sold commercially.

Do you want to sell prints of this model or any of my models? You can purchase commercial licensing at Patreon or Buy Me A Coffee. Earring Commercial Liscence is just $3 a month. A full commercial license for all of my designs is just $7 a month.