SUPER AMS Lite Snap-On Top Mount Remixed by Supergrapher

Remixed by

Supergrapher

3D Printer>3D Printer Accessories

Print Profile(1)

All

0.2mm layer, 2 walls, 15% infill

Designer

4.1 h

1 plate

5.0(15)

Boost

110

Released

Description

NO ADDITIONAL SCREWS NEEDED! SNAP-ON DESIGN!

I have 2 A1s and I used Bambulab's top mount for my first printer, but when I wanted to print a second one the second printer, Whoa! there were so much inefficiencies in the design that I had to make my own improvements! So here I present to you my own Super AMS Lite Top Mount! The advantages are…

No additional screws needed! You just need the ones you take off from your AMS Lite
Snap-on design
Prints without support
Uses less filaments (about 40% less!)

Instructions

Slide in the mount over the top railing, it is tight, but it should just barely pass through
Attach the clip to the upper section first and press it press it firmly with a "click" to fasten it to the lower section
Attach the AMS Lite using the same screws

*Note this is a non-rotating mount

I designed this from scratch but since I used the measurements of the Bambulab mount I'm marking it as a remix.

Have Fun!

Check out my other A1 related upgrades, https://makerworld.com/en/@Supergrapher

Comment & Rating (25)

@user_77127594

I printed this in ABS-CF. Light and stiff with high heat resistance! 💪 seems to hang in there will even with my A1 enclosed from the AC that makes things pop off the plate.

@Synthy87

Boosted

Booosted you!!! You deserve it. Thanks a lot.

(Edited)

@mousevc

Print Profile

0.2mm layer, 2 walls, 15% infill

super

@user_1894159733

Print perfectly! going to try it out for a few days

@Synthy87

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

This is superb design!!! Still in testing, but it works fine.

@mousevc

works great for me from te first print

@MrJimbob23

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Printed great and cleared up some needed desk space!

@actisalessio

Don't we need other supports underneath for the z axis?

The designer has replied

@Supergrapher

You mean extra braces? It works ok for me without, but maybe I'll design some to go with the top mount.

(Edited)

@Synthy87

Boosted

I printed out a set of stabilizing mounts for the A1 from this model. https://makerworld.com/en/models/90586#profileId-96991 The printer is stable when the AMS is fully occupied.

@craftbyildi

I love that cover on the film, it is printed too ?

The designer has replied

@Supergrapher

Yes, here is the link, https://makerworld.com/en/models/188758#profileId-208077

@stevevu

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

printed great and works well

This remix is based on

AMS lite Top Mount for A1

Bambu Lab

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.