DIY shifter for simracing.

Tools needed:

• Soldering iron + tin
• Flathead screwdriver
• 2mm hex screwdriver
• Superglue
• (jumper wires)

Hardware needed:

• 16 - M3x20 buttonhead screw
• 16 - M3 brass insert
• 2 - 626RS ball bearing
• 2 - 6000RS ball bearing
• 2 - M6 nut
• 2 - 10x17 compression spring
• 1 - 8x35 compression spring
• 1 - 9x30 tension spring cut in half
• 1 - M10 threaded rod cut to 55 mm length
• 1 - M6 threaded rod cut to 70 mm length
• 2 - microswitches - type does not matter
• 1 - Arduino (Uno, Nano, Mega…)
• Some wire.

The assembly process i pretty straight forward if looking at de photos. the bearings should be a slight press fit.