Hi, I'm sorry you had issues! The outer ring would have typically been the same blue as the coaster but since I don't see any blue around the outside I am going to look at just the white. Did you by chance have supports turned on? There is a small gap between the outer ring and the centre of the coaster but it is able to print over it cleanly and no supports are needed. In your photo it does look like some of that gap is filled in with lines (which looks similar to what I get if I add supports to the profile). It also looks like the first layer did not adhere well in some other areas and the white outer ring ended up tangled (maybe with the supports?). I do have the first layer slowed down but you can slow it down more, wash your plate and/or increase your plate temperature to 60 to help with that. If you make sure supports are turned off and you have a clean plate you should be OK. I'm sorry it didn't work the first time!
German version brought to you by Google Translate:
Hallo, es tut mir leid, dass Sie Probleme hatten! Der äußere Ring hätte normalerweise das gleiche Blau wie der Untersetzer, aber da ich außen kein Blau sehe, schaue ich mir nur das Weiß an. Hast du zufällig die Unterstützung aktiviert? Es gibt einen kleinen Spalt zwischen dem Außenring und der Mitte des Untersetzers, aber er kann sauber darüber drucken und es sind keine Stützen erforderlich. Auf Ihrem Foto sieht es so aus, als wäre ein Teil dieser Lücke mit Linien ausgefüllt (was dem ähnelt, was ich bekomme, wenn ich dem Profil Stützen hinzufüge). Es sieht auch so aus, als ob die erste Schicht an einigen anderen Stellen nicht gut haftete und der weiße Außenring sich verhedderte (vielleicht mit den Stützen?). Ich habe die erste Schicht zwar verlangsamt, aber Sie können sie noch weiter verlangsamen, Ihren Teller waschen und/oder die Tellertemperatur auf 60 °C erhöhen, um dies zu erleichtern. Wenn Sie sicherstellen, dass die Stützen ausgeschaltet sind und Sie eine saubere Platte haben, sollte alles in Ordnung sein. Es tut mir leid, dass es beim ersten Mal nicht geklappt hat!