This is pod for the boost gauge in my 2005 Audi A4 B6. I couldn't find anything created for this car to mount a gauge and I didn't want to buy the replacement vent with the gauge in the centre. To install the vacuum line and power to the pod, I drilled a 1/4" hole through the air duct to feed the lines up through.
I had to wrap my actual gauge with a couple layers of tape for it sit snug.
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.15mm
Infill:
15%
Natural
Notes:
I printed this in PETG but PLA or anything would work fine.