Low Profile, High Airflow, LED riser for X1C/P1S by Henryk

Henryk

3D Printer>3D Printer Accessories

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 25% infill

Designer

5.5 h

2 plates

4.8(17)

0.2mm layer, 3 walls, 20% infill

5.3 h

2 plates

Boost

144

120

Released

Description

This is a low profile riser for the top cover glass of the X1C and P1S/P1P 3D Printers.

It is designed for optimal airflow while being very slim and using very little material. You can print it without supports and assemble it without glue.

The riser has an angled lid on the inside for attaching an LED Strip. You can use most USB LED Strips.

I've used the 5600K White Light LED strip sold by bambu lab and plugged it to the internal USB connector of the printer.

The riser has little clips you can use for cable management.

You will need some interface material between the riser and both the printer and the glass top to prevent vibrations and rattling. Small strips of double sided tape work great for me. Thin EVA Foam should work as well.

Comment & Rating (22)

@madmorgans

Boosted

Print Profile

0.2mm layer, 3 walls, 25% infill

excellent used my little hobby vice to press joints together thanks it's just what I needed 😀

@3dbutze

Hi Madmorgans, what i this thing in front of the AMS ?

@madmorgans

Boosted

hi it's a tapo c110 wi-fi camera the p1s camera is annoying so this lets me check prints in real time I found this was the best way to mount it and got the mount print off printables

@3DprintK81

Print Profile

0.2mm layer, 3 walls, 25% infill

great job 💪🏻👍🏻

@TNTMoore

Print Profile

0.2mm layer, 3 walls, 25% infill

oh yeah! Just what I was looking! not bad at all! i had to reprint but only due to issues with my filament- all good on your end!

@ZzbezZ

Print Profile

0.2mm layer, 3 walls, 25% infill

non male ma ho preferito solo gli angolari

@WillowTattoo

Print Profile

0.2mm layer, 3 walls, 25% infill

love this design, simple, printed super easy and just works perfectly! I added a cob light strip I got on Temu, pretty sure it’s only 1m - it goes 75% of the way around which is all you need added a picture with the door closed, open and on the app

@Noctys

I really like this design, so I decided to give it a go; I had to start over each plate a couple of times because of issues with the print. I've never had problems like that before, but I'm not sure why it would just be with the file. Once printed however, it wasn't as great as I had hoped, as the glass rattles during printing. I tried to put a very thin layer of cloth between the print and the glass, but the lip was too small, and the glass wasn't secure afterward. Looks really nice, but ultimately unusable for me. Would probably work well if I had my AMS on top of the printer as the extra weight would keep the glass in place.

(Edited)

The designer has replied

@Henryk

Hey, you will need some Material to dampen the rattling. Small strips of double sided tape on both the glass and the bottom of the riser work great for me. Just enough to prevent the vibrations but still easy enough to remove when needed. Thin EVA Foam should work as well.