So this guy, Johan Vandenberghe Fine Art Photography (@rarecarreverie on Instagram)
apparently shot with his camera the absolute nuts hueforge picture! 😮😮😮

(I contacted him by DM and made him aware of me borrowing this picture for this.
That is why licenses on this file are so restricted: No remixes nor commercial purposes.
The most kudos for this artwork are to be credited to him, not me this time.
Tho I couldn't resist to hueforge such a perfect image!)

My flowrate multiplier was set >1 because of the black, which is fine calibrated like that, but it turned out being a bit excessive for (my) white. As long as you profile your filaments correctly, or just leave it to default 0,98x and 0,020 K value, the white shade on the background garage door should come out better than shown in picture.

It's set as a 7 colors, this because I like to use a very low TD white on top of a regular white, to shine up the lights a bit.
I think you could get away with a 6 colors, just the normal white should be fine enough.
To have it 6-colored just delete the last pause/color change at level 28 or ignore it by just clicking >Play without changing filament.

I use pauses instead of color changes because I want the profile to be usable for who doesn't have an AMS.
Further I often use more than 5 colors and my prints are one-off, expecially this one. Setting up for use of the AMS would be a hassle for a one-off, not counting for the rolls which don't fit into the AMS (Amazon Basics specifically, here).
So here it is, just change the pauses for color changes following the same swap instructions:

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA Sunlu Meta Black Transmission Distance: 1
PLA Amazon Basics Dark Brown Transmission Distance: 6
PLA BambuLab Basic Red Transmission Distance: 4.5
PLA Amazon Basics Orange Transmission Distance: 3.6
PLA BambuLab Basic Yellow Transmission Distance: 5.5
PLA SunLu Meta White Transmission Distance: 6.6
PLA Amazon Basics White Transmission Distance: 2.7

Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Dark Brown
At layer #12 (1.04mm) swap to Red
At layer #19 (1.6mm) swap to Orange
At layer #22 (1.84mm) swap to Yellow
At layer #25 (2.08mm) swap to White
At layer #28 (2.32mm) swap to White 2.7 TD for the rest.

Hope you enjoy! :)

-H.