0.08mm layer, 2 walls, 15% infill - The Thinker A1 mini friendly
Came out pretty good overall in Bambu Gold Silk PLA but the supports were difficult to remove as they attached to both hands which are very fine. On one hand I broke off a couple of fingers and on the other had to leave some support in place.
these are very nice models. printed with hatchbox granite pla and Grey pla and they turned out great. supports are required and require careful removal particularly around fingers.
Printed just the David, easy to print. I just had to pay a bit of attention removing supports in the hands.
I've printed it with an extra wall because other reviewers had the legs broken.
Tried printing this twice, one without support and one with. It failed on the right arm (its left) on both occasions, maybe it was me but I wasted a lot of expensive filament so won't be trying it again! Such a shame because they look great.