Not sure why is loose for you, I am sorry to hear that. I printed few and for each of them I needed to use pressure to get it in.
I hope it works good. For me it works 8 of 10 times. I still sometimes get some poop on the bed, but it is only if it catches to the side where is aluminium tape. If it catches there there is no way to stop it. I tried different models before I made this one, and there was a issue filament getting stuck on pieces that were extended.
Thank you for downloading and rating. For me 8 of 10 times works. If filament get stuck on side where is alu tape it gets out sometimes. cannot be prevented by any cover unfortunately.
Absolutely, sorry, I did not make that clear for everyone. Unfortunately, Makerworld only allows 3 stars max if the first print did not succeed and you retry directly using your printer's display.