Card Dealer Shoe With Magnetic Discard Tray
Remixed by
Copyright Claim
Card Dealer Shoe With Magnetic Discard Tray
Remixed by
Boost
12
19
13
Print Profile(1)
0.16mm layer, 2 walls, 12% infill
Designer
8.9 h
3 plates
Boost
12
19
13
2
46
26
Released
Description
Remixed and resized to allow for standard size playing cards to sit fully into the discard tray. The discard tray can be turned upside down to have a 2nd basket ontop of the base of the discard tray.
I think it could fit up to 5 decks of cards at once.
5/14/14 UPDATE - The bottom tray piece was incorrect. Sorry. I fixed it and reuploaded the correction. If you've printed the original file, use plate 3, which has the updated piece needed.
This model uses:
(QTY) 8 - 10mm x 1mm magnets
1 Rubberband
Comment & Rating (13)
All
is there an updated piece for this to fit ? or do I just not understand how to get it on
The designer has replied
0
Reply
let me check my files on this to make sure I have the correct one uploaded. there should be only one version of this piece however. it should slide into the back of the main body.
0
Reply
so that piece pictured should be fine, but there was an error on the upload file for the base plate piece. it's now on its own plate, so please check the newest upload file and print plate 3 to get the correct piece. sorry about that!
0
Reply
am i missing something? the tray isn’t sliding in and can’t close the back,
The designer has replied
0
Reply
sorry mate, let me check my files and reupload a correction. I'll message you when done.
0
Reply
the base plate part was incorrect, but I uploaded a correction. please reprint plate 3, for the base plate part. let me know if there are any issues!
0
Reply
printed good
The designer has replied
1
Reply
great, thanks for the feedback. I had a prior issue with one part so I'm glad to see it's been resolved
0
Reply
wie wird es zusammen gebaut in der unteren Platte ist keine Lücke wie im Original
The designer has replied
0
Reply
Von welchem Teil redest du? Möglicherweise habe ich das falsche Stück hochgeladen, benötige aber genauere Informationen. Tut mir leid, wenn meine Worte schlecht sind, ich benutze einen Übersetzer
0
Reply
this has been corrected. base plate part has been fixed.
0
Reply
Print Profile
0.16mm layer, 2 walls, 12% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 12% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld