DnD Player Character pack1 miniatures
Remixed by
Copyright Claim
DnD Player Character pack1 miniatures
Remixed by
Boost
49
103
10
Print Profile(1)
0.12mm layer, 2 walls, 15% infill
Designer
12.9 h
1 plate
Boost
49
103
10
3
208
103
Released
Description
Remixed to allow for magnets in the bases for easy storage
| My DnD miniatures | ||
|---|---|---|
 |  |  |
 |  |  |
 |  |  |
 |  |  |
 |  |  |
All my models | ||
Comment & Rating (10)
All
Print Profile
0.12mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
I only printed a few of these models before I stopped. They are nice models, but there is so much support for some of them it is really hard to get it off with breaking the small model. (This happened for me on the rogue model; the downward blade broke off even though I was trying to be extremely careful.)
I might come back and print some more of them if my kids like them, but I think I should look for models that print with less supports.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Perfect prints (:
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
printed great on P1S without a flaw. There are lots of supports, but they’re fairly detailed models so it goes with the territory. leave yourself a little while to remove supports, and enjoy!
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
turned out great except the one caster, the spell never seemed to turn out.
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
printed beautifully, supports were easy to remove, great figures
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
Missing Model Parts:some of the people broke while printing
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 15% infill
(Edited)
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld