FMS ATLAS 6WD REAR PETROL TANK CARRIER ADDITION

A new look for the famous FMS ATLAS 6WD now tranqformed in lpetrol tank carrier.
It looks like trucks in Spintires, Mudrunner and Snowrunner video games.

One main frame is fitted onto the truck, you just have to remove all rear plastic parts on the rear area of the model

On the frame 4 side fixtures are fitted and a main tank is centered on the frame and glued. You have to print the tank verticaly and add the rear end by glueing.
Same for the 2 top fake openings using the jig for fitting them symetricaly
Rear ladder is added as well and 2 side conncecting boxes made of 3 parts are glued in place. On the other side you have 3 pipes part which is printed also verticaly and finaly glued on the main frame.

You need M1.4 screws to fit the rear of the main frame in the last rear holes of the Atlas chassis frame.

Very simple to print on small machine. You have some plates to fit the rear light. It is tight adjusted to the cabin, the tank must be glued flush with last front surface of the main frame.

4 rear holes on the rear are ready to fit the rear hook fixture included in the file set. In case you want to tow some trailer behind, specialy a tank trailer for sure ;)

As usual you have to redrill holes to 1.2mm when a screw has to screw in and redrill to 1.5mm when a screw has to go through freely.

Parts have to be located properly on the bed as I don't know how to do it at the design phase.

Nothing special bed 60°C nozzle 205°C speed 60mm/s