Jörmungandr-Pattern Armored Fighting Vehicle

*Update v4: Screwed up the geometry for the Grav Sleds. Fixed, resupported, and reuploaded. Also included a seperated version of it for printing on smaller prints (front, middle, rear).

*Update v3: Free updates to add grav sleds to the Jormungandr, reverse engineered from my Polaris.

*Update v2: Fixed Turret Mounted Heavy Stubber & Storm Crows presupported version. Old pintel mount was too large. Reinforced presupports on interior of Front Hull to prevent warpage. Included presupported version of Heavy Onslaught Gatling Cannon that was previously missed.

The Jörmungandr-Pattern Armored Fighting Vehicle is a monstruous, and some would say maniacal, feat of engineering from the Tech-Priests of Skara Prime. Designed during the War of Reclamation, the Jormungardr got its lengthy name from armored battalions circumventing the surface of the planet in their effort to uproot the Xenos rot that had crept across the planet.

A general purpose fighting vehicle equipped with anti-tank weaponry equally good at destroying vehicles and the hostile fauna of Skara Prime, the Jörmungandr saw constant action during the effort to retake the planet. Equally suited for carrying troops, crossing hazardous terrain, and urban warfare, it became a main stay of the Imperial Regiments.

Eventually, once Skara and its inhabitants were wrapped into the fold of the Imperium, the Jormungadr was decommissioned from guard regiments. It however found new life in Space Marine Chapters undersupplied following the conflict, where Forge Worlds had yet been able to reinforce them with more commonly used vehicles.

Model measures 190mm x 115mm x ~95mm. (Varying height depending on turret configuration). Scale is slightly longer ~10mm than the GW model.

Features:
- This kit proxies for Repulsors and Repulsor-Executioners.
-Fully modelled interior compatible with Marta_Punkgirl's Prime Sitting Bois. https://cults3d.com/en/users/marta_PunkGirl/3d-models
- Removable hatchs for a tank commander or weapon systems.
- Remote CROWS style stubber and storm bolter.
- Simple, easy to print push-to-fit design.
-All weapons, sponson options, and turret accessories are fully magnetized.
- Turrets are cross compatible between the majority of my models, enabling you to switch them out for crazy kitbashing (IE, this turret can be put on the chassis of my Fenrir tank or Charon Apc and vise versa).
-Fully Pre-Supported. Make sure your exposure and settings are dialed into prevent failures or support scarring.

Test Printed on a Mono X 6k with auto-supports in Chitubox using Siraya Tech Fast ABS-Like Navy Gray

1.8s exposure
0.02mm layer height
15 bottom layers at 23s exposure
20 transition layers
60mm/s lift speed
Large parts (Turret, Skirts, Hull) hollowed at 2mm with drain holes hidden in magnet slots
Angled to approximately 45 degrees