30K DEIMOS HIGH DETAILED INTERIOR RHINO

This is a 30k Deimos Rhino, with extra Details inspired from the old RT era. All bolters eg on the cupola, under the computer/radar screen and in the Weapons Racks are Umbra pattern for the Heresy

So external details include extra studs, a Air scrubber/filtration its on the center hull at the back (inspired from the RT Rhino)

Internal details inspired from all the Jump seats and cubby holes we have on aircraft. So you will find multiple lights, jump seats for a full squad of 10, gun racks (they fit at the front both left and right sides, spare tracks both sides, tools both sides, (Chain sword and power axe located in the bench seating) power hammers both sides (For fixing of tracks as well as bashing other things). Computer screens/radar monitor, and multiple hatch locations including in the ceiling near the exit. And of course im safety first, so you will find the fire extinguisher is on the bench seating

Seating comes in multiple options with Jump seats UP/DOWN or a Mix thats on all the parts eg Track, Hull or the bench seating center section

The Hull both Track and center section have 2 different floor patterns to choose from either Parallel or Cross Hatch design

Outer detailing, working rear Hatch, side doors and top doors, including the cuopola hatches, and 2 versions of the grab bar, if your printer is good (mine a bit old so struggled a couple of times) use the thinner version, otherwise use the Thicker one

11 Dozer blades/Rakes to choose from

The Legion Iconography will be in separate designs, will start uploading them soon

The Top doors have options for with or without the RT style outside handles.

This should be the same footprint as a standard Rhino, I adjusted the outer tracks to be slightly sider and the center section to be slightly slimmer for a more aggressive look, and as you can see the way ive done the interior makes it look and feel way bigger then this round door to square door rubbish FW has.

The round circle doors have working Hinges, (RECOMMENDATION FOR ALL MY HINGE FITTINGS, warm the part with a hair dryer before putting the door/top cupola hatch into the hinge) Make sure the Hinge is clear of any flashing from the printing and once in place work the item a couple of times open and close to make sure its smooth. Fit the side doors in place with the hinges facing 90 degrees, after sanding if require (depends on how good your printer and resin are) apply a small amount of glue on each hinge and rotate them back onto the hull.

The side Tracks and Center Hulls are already hollowed with Vent holes. The side tracks alone have 10 (yes 10) drainage/vents to make your printing easier. the Center hull has 4 drainage/vents.

Every part shows no faults in Meshmixer no reverse faces etc
Made in both Meshmixer and Blender

I spent a long way way to long time on this one lol id say a minimum of 2 weeks on her. All parts I've tested and printed on a Epax X10 (Early one so no mono, no 2k screen etc and as its on a larger format the resolution is quite low)
The resin was the cheapest and being honest its also 1 year past expiry lol.

Please I want to see your prints of this one

Any issues let me know and ill see what I can do, please remember this is not my Job, so give me a couple of days to see the message depending on my shifts. Regards Boredpilot