Humidifier Planter
Humidifier Planter
Published 2020-06-28T07:35:21+00:00
This Planter gives you a mist that fogs down to the near pots. Moving the air dial will allow more air making it mist more or close it to keep the fog on top of the tower. I would not recommend adding essencial oils, doing so will most cog the mist maker. If you cant or dont want to have the mist you can still print the other parts to have a spiral of pots around it.
Parts needed
-Drill
- Super glue
-Sodering iron
- Hot Glue gun
Super glue all the side base with the Center base and the Electronic base. Once all the lower bases are glue together you will have the main base. In my build im useing 2 40mm pot , 2 60mm , 1 80mm. You can make it different if you like, also i use cura and you can make the pot bigger make the Y axis bigger. Drill is only to make drain holes in the pots, i am working on uploading ones with the holes already premade. when adding the center tower add hot glue to the water hole the circle , around it to make it water proof. the square hole is for the air getting push by fan. When adding the mist maker add a bit of cotten in the center hole to make it better for it to suck water up to the mist maker.
WHDTS 20mm 113khz ultrasonic atomization maker mist Atomizer DIY Humidifier PCB 3.7-12v
40mm x 40mm x 10mm fan
both can be found in Amazon.
NO Mist Maker
If you can't make the mist just replace the electric base and the center base with two more side base. So you will need 7 Side bases and superglue them. This will give you 2 more spaces to but more bases and you can be creative and organized them in different patterns.
Date published | 28/06/2020 |