VESA mount holder
VESA mount holder
3D
Published 2020-02-14T11:51:09+00:00
Mounting solution (holder) for Mini PC like "HP 260 G2", "HP 260 G3" and all other VESA-compatible devices
I needed a simple and inexpensive solution for attaching a mini PC to a display. But branded mounts from HP are expensive, so this solution was invented.
This mount is great for devices and monitors with a VESA 100*100mm mount.
The use of this mount is not limited to the display only. You can use it on other surfaces: wall, table, under the table(!). When attaching to wooden surfaces, the screw must be replaced with a wood screw for of suitable length (for holder-final-part3.stl)
Additionally, 4pcs M4*12mm and 4pcs M4*15mm flat head screws are required (In my case).
The length of the screws may vary in your case (depending on the monitor and device)
The part holder-final-part1.stl must be screwed on without special effort, so that the part after installation can be turned 90 degrees down. See photos.
One mounting kit required:
holder_final_part1.stl - 1pcs
holder_final_part2.stl - 3pcs
holder_final_part3.stl - 4pcs
The model is absolutely free, but I will be glad to reward :)
Highly recommended only PETG plastic. Other plastics do not have enough strength.
One mounting kit required:
holder_final_part1.stl - 1pcs
holder_final_part2.stl - 3pcs
holder_final_part3.stl - 4pcs (Skirt/brim required)
| Date published | 14/02/2020 |
| Time to do | 120 - minutes |
| Support Free | YES |