Amazon FireTV Cube Wall Mount
Amazon FireTV Cube Wall Mount
Published 2018-09-17T13:12:09+00:00
Wall mount for the new Amazon FireTV Cube. This wall mount allows the FireTV Cube to be easily affixed to a wall using 3 screws with low profile heads. Proper ventilation slots are present on the sides and rear of the model as well as a full length cutout for cable connections. Existing cabling can be used without modification and will hang down from the attached mount.
This design prints with minimal support material and does not need a raft to successfully complete the print unless necessary for your printer. *See print settings below for additional printing information.
Total printed material weight: 47g
Total model material weight: 40g
Total support material loss weight: 7g
Version1.5 Update: Corrected default model orientation so that it does not require additional adjustment in slicer for printing.
Print the model with the square slotted vent side down. Enable supports everywhere so that the vent holes, and bottom retention ledge print correctly. You will need to remove support from the 4 side vent slots, the back vent slot as well as the cable connection cutout. If using ZigZag support; the back vent slot, cable connection cutout and retention ledge supports remove as a single piece.
*Pay special attention to removing the side and rear vent slot support as the wall directly above is only 2 perimeters thick.
*I used flat top screws to affix to the wall. There is sufficient clearance under the installed FireTV Cube to use several styles of screw or nails, but it must be able to fit a 4mm hole diameter.
Date published | 17/09/2018 |
Time to do | 330 - 400 minutes |
Material Quantity | 47g |
Dimensions | 90.2mm x 90.3mm x 81.6mm |