Fx Panthera bundled Slug magazines

Updated 20 Marts 2023:
1. Added the .30 caliber of the Panthera magazine

1. Added a new flip covers for each caliber without text.

Take advantage of the fresh designed FX Panthera Magazine with flip cover. Here in bundle release including .177, .22, .25 and now also the .30 version.

It is designed especially to be good for Slugs, but it is working ok for pellets too. There is plenty of room for long slugs. Fits easily the H&N HP .22 40 gr. Slugs All cal. versions have same available space.

Link to an instruction video, how to finishing the magazine after printing: https://youtu.be/wunxeoAX39A

Further information about spring and assembly here:
https://1drv.ms/b/s!AmpEb51MwLqTh_cxLXGupN7SXw9Ycg?e=i4dbLF

There will be a new video shortly, explaning how to finish a Slug magazine version

Link to how to make the Tension spring:
https://youtu.be/AMW_z_x5rE0
Same as in the above video but use a round 8 mm rod to these magazines

Further information about spring and final assembly here:
https://1drv.ms/b/s!AmpEb51MwLqTh_cxLXGupN7SXw9Ycg?e=i4dbLF

Shopping list can be found here:
https://1drv.ms/w/s!AmpEb51MwLqTh_RjguKuO8SxN8lS3w?e=pTEGHm

I use ABS printed on a glass bed with DimaFix spray at 100 degrees C.
I also sometime use Petg for the body, washer, and cover, but very seldom for the rotor. The rotor is coming out of the printer with superior quality – specially numbers are easier to print with ABS or in this case ASA.

I print all with 0.16mm layer height. Be sure to calibrate your printer at optimize your slicer. Everything is designed to 0 tolerance so use your slicer XY horizontal compensation.

Print the rotor with the numbers towards the print bed.
I prefer quality over speed so i print at 50 mm/s.
When I print with ABS scale the parts in X 100.4% and Y 100.4% not in Z.

Cut m3 threads in the 3 holes for the m3x8 countersink steel screws andfor the center screw.
Use two ø6x 2,5 neodym. magnets for the cover.
(I use ø6 x3 since they are cheaper). Just screw the two m3 screws just below the body surface to absorb the 0.5 mm the magnets are too long.

Use a 1.2 mm steel or carbon rod for the hinges. Drill free with a 1.2 mm drill first while the cover is fixed in place. (You can fix the cover temporary by the 2 screws for the magnets before fitting the magnets,

Infill 30%

Supports when printing.
Body: only touching bed.
Cover: no supports
Washer: no supports
Rotor no support

I recommend using the .3mf files over the .stl files - The .3mf files will give smoother roundness.