Winterkette Type 6 w. ice cleats in 1/35th scale for Panzer III and Panzer IV

Workable track for 1/35th scale models.
This is a Winterkette based on the Type 6A standard link. It was produced from Autumn 1942 on. This is variant 2, it has additional ice cleats on the surface making contact with the road.

This is a very accurate recreation of this track link. I do own an original Type 5B, I 3d-scanned and used it for reference for guide horn and core geometry, the Type 6 specifc parts were measured from a museum vehicle, the data on the "fin" or Winterketten-part I obtained through a collector.

There are 3 options for joining the links together:
1st. I've included printable pins in full or half length.
2nd option is a click system that doesn't require any pins. Fair warning, it does highly depend on how well you dial your exposure and post cure process in.
3rd option: The traditional wire method, just use copper motor core wire around 0.3 to 0.4mm diameter. It is easiest method, specially for older printers and standard resins.

Links are included blank and pre-supported (cad designed supports): Pins are included blank, pre-supported and as a pattern of 100 in both "head-up" and "head-down" variants.

License is for private use only. You are not allowed to distribute or the sell the files or prints. Merchant License can be obtained via Patreon.

In case you need help with my designs, feel free to contact me.
Thank you very much.

I've created a short video and article with instructions and information publicly on my patreon page.

If you have further questions, feel free to contact me.