Adjustable phone stand 3D print model

Hi, this is model of adjustable phone stand. It can be tilted at a great angle. There are 10 positions with 7,5deg steps. The stand consists of 2 parts - base and C holder. To tilt C holder just press buttons on the base (from both sides). Buttons are inegrated into base design and easily 3D printable. The only element which needs support is the guide slot in C holder, but the support block is part of the model. This block works for me well and can be easily removed. If you choose not to use the custom support, you can remove it in your preferred slicer and let it to build automatic support. After removing support you may need to clean the upper edge of guide slot (the one that was supported).

The C holder comes in 4 variants: 1/ plain variant 2/ with rib stop for landscape phone orientation 3/ with hole for charger plug (charging possible with greater tilt due to plug length) 4/ with hole and rib

3D printing info: Printed with PLA on PRUSA MK3S+, 0.2mm layer height, 3 perimeters, 10% infill, temperature 215C.

3D printing tips: 1/ turn on thin wall detection 2/ turn on bridging perimeters detection

YouTube: https://www.youtube.com/watch?v=Ui2k4B64ZFc

Also check out: https://www.printables.com/social/52878-rorys3d/models