Tonka Winnebago Styled Camper but for TRX6 wheelbase

So the TRX6 is a cool truck with 6 Wheel Drive. This camper was designed to fit its wheelbase according to information on the Traxxas site. I do not own a TRX6 therefore cannot integrate any body mounts or interior since there is no way for me to know what will go where. I will see if I can borrow one and make any adjustments needed and possibly design a full interior.

Included:
Front Light Buckets(made to take 10mm and 5mm LEDs)
Headlight would be white 10mm LEDs
Indicator LED would be 5mm amber LEDs

Rear Upper Light buckets (for 5mm LEDs)
Can be printed clear and use Red 5m LEDs
OR
Printed in Clear red and use white 5mm LEDs

Rear Lower Backup Light buckets take 5mm LEDs

Not Included:
The Clearance Markers are not a printable items, They are actual rectangular 5x2x7mmLEDs in the colour needed. In this case either Red for the rear or Amber for the front and are simply inserted into the slots provided. Once positioned into place they are Held by a dab of CA Glue or even hot glue.

It come with 3 types of wheel setups
Printable Tire and wheel
Printable Wheels for glued tires
Printable Beadlock Wheels for a larger variety of tires

Printable tires are about 3.9"/94mm high. You can probably go bigger but I do not know how the wheel arches will fit.

Required
28x 2mm Self tapping Flathead screws.
Pre-drill holes with a 1.5mm bit or splitting may occur.

Orientation and any other preferences are up to you. However, for the most part there are not much supports needed. This will also be determined by you and you printer's capabilities.