This is an insert for plant pots that has a hole at the bottom for drainage. Insert this thing in a beautiful plat pot that has no drainage hole. You basically plant your flower/plant/succulent directly in here and then place the thing in your pot. This thing is not visible once it's inside your pot.
I've also included a bottom support to keep the plant and earth away from the pot so that the drainage will actually work.
IMPORTANT: There are two models of the insert, one a typical 3D model while the other one is for use in "vase mode" or "spiral vase mode". Vase mode prints much faster and yields a sturdy enough part for use as an insert.
ALSO IMPORTANT: You need to pay attention to two (2) little things:
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.3 mm
Infill:
10% for bottom support
Notes:
Print in the same orientation as shown in the images. No supports needed, but I used a brim for the bottom support just in case (very easy to remove). Keep in mind that none of these parts will be visible once in your pot, such finish quality is not important.