The model was inspired by the ORIGINAL PRUSA SL1. The orange cover is removable, so if you would like to, you can see the inner design of the lamp. When turned on, the SL-Lamp´s face and the cover lights up.

It is fully printable on the PRUSA MINI, or the PRUSA i3 series, with or without MMU2, and it is fully printable without supports.

Check the photo gallery, every detail is there which You need to know to build the PRUSA SL-Lamp: Technical specifications, bill of materials, printing instructions, assembly instructions with pictures, and other information.

If You like the model, feel free to share, download or modify it :)

Print instructions

(For more information check the photo gallery, there You can find bill of materials and other useful informations)

In short:

You don´t have to rotate anything, everything is in correct position, and printable without supports.

As printing material, I recommend you to use PLA, except for part G (the "build plate"), which holds the bulb, so for the part G use PETG, ASA or ABS if possible.

Preferable nozzle is 0,4 mm

Because there is not much rounded surfaces on the model, you can chose a resolution from 0.05 mm to 0.25 mm, although, for the SL-Lamp face it is necessary to use 0.2 mm layer height.

The print speed depends on your setup, but I recommend using slower speeds especially for the orange cover and the threaded rod.

For the orange cover use higher infill, but moderate part cooling, or no part cooling at all.
Except that part you can use less infill (15 % – 30 %)