Made the plug 2x as tall and slot down the middle to both hold the other piece in place and allow a charger to pass through and used it to hold the phone stand in place
I made this phone holder to solve the problem of low refresh rate camera that the P1 printer includes and make use of my old phone.
it slots into place in the hole at the top of the printer with a pass through to allow a usb charger to be plugged into the printer and come out cleanly and keep the phone charged while recording.
Steps to make work with different phone:
1) use the stl without the phone slot
2) find stl of a case for your desired phone and remove the right half of the case
3) angle the case to 30 degrees and line up with the solid side of the stand