Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
2 h
1 plate
Boost
11
17
3
1
17
13
Released
Description
Print at 100% infill (if scaled up) with a layer height of 0.16mm with a base layer of 0.2mm
This print uses 4 filaments
Swap Instructions:
Start with Charcoal Black
At layer #4 (0.68mm) swap to Dark green (light saber layer)
At layer #7 (1.16mm) swap to Lime Green
At layer #11 (1.8mm) swap to White for the rest.
I replaced the Dark Green light saber layer with glow in the dark filament seen in the grey slice photo for mine.
Happy Printing and May The 4th Be With You!!
Comment & Rating (3)
All
Boosted
Print Profile
0.16mm layer, 2 walls, 15% infill
May the 4th be with you too!! I reduced the size and printed with a 0.2mm nozzle, so these are only 2" across, but they came out great. Thanks.
1
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Great results
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld