Tip jar ♥ https://ko-fi.com/cosmicnimbus 
Patreon - https://patreon.com/CosmicNimbusPrinting 
Gumroad - https://cosmicnimbus.gumroad.com

Hi there !

There are quite a few lamp shades around, but I wanted to try out making my own. It was pretty simple in the end and turned out ok so I thought I'd share it !

Here is my lamp
https://www.kmart.com.au/product/leo-table-lamp-43110070/ 

There are 2 versions of the shade. The first one had a 27mm gap for the lightbulb, which fits the standard bulb screw, but stops the bulb from screwing right in on this particular lamp. The second is a bit wider to allow the bulb to screw right into this shade.

This model is made to be printed using vase mode.

I printed this in Polymaker Marble White PlolyTerra, at 0.28mm layer height

Happy Printing !