Introduction

This clock has a transparent window through which you can see the ‘poop’ that our wonderful printers produce when we need a multi-material design by using the AMS.

You get to choose the colours of your poop waste material, whatever best suits your design flair.

This is just one of my Filled Clock Collection.

How to use

The Poop Clock (or Time Waster as I call it) prints the main body in one piece and benefits from you having a transparent material (PLA or PETG for example) as without it - the effect doesn't exactly work as well.

You place your poops into the hole in the top whilst shaking occasionally (and gently) to allow you to fill it without gaps. Once you have carefully jammed as many poops as will fit, slide the door into the slot over the hole and your poops are as snug as a bug in a rug.

Choose the stand to mount it on a flat surface or use the hook for the wall.

Using the Stand

• Insert the stand into the bottom slot below the clock mechanism pointing downwards away from the door.

Using the Hook

• Insert the hook into the top slot above the clock mechanism and towards the hole.
• Insert the spacer into the bottom slot below the clock mechanism pointing downwards away from the door.

Included Parts

• Clock body
• Stand - so you can place it on any flat surface
• Hook & Spacer - to place it on a wall nice and flat
• Door - to keep your poop inside as it should be
• Hands - sized to the most common clock mechanism*

Required parts

• A clock mechanism, can be purchased from Amazon (like I did) or the Bambu Lab Clock Hardware Kit should work, I have NOT been able to check as the U.K. still doesn't get them until sometime in May 2024!
• Transparent filament; PLA or PETG for example, without this you could use white, the transparent material is printed at a SINGLE 0.2mm layer.

* I cannot possibly provide a set for all potential hole sizes. I recommend you use my Diameter Sizer 1.0mm to 5.9mm tool to determine the correct diameters and I may be able to create a set for you.