A nice working windmill with a place for a motor (not mandatory - see below) and a setup for a 5mm LED.

No AMS Needed, each part is a seperate print and the colors on the doors and windows are configured by layers (old school).

Parts List
1. 3-6 M2 4mm screws (Top might be ok without it).
2. 1 M3 35MM screw for the NON motor version.
3. low RPM GA12-N20 motor - NOT MANDATORY (See below).
4. LED - 5MM or any other - NOT MANDATORY (See below).
5. ON\OFF Switch - 10mm x 15mm - NOT MANDATORY (See below).
6. 5.5mm x 2.1mm DC Jack - NOT MANDATORY (See below).

Print
The mill has 5 main parts:
1. Top
2. Mill
3. Base
4. Wings (More on that after)
5. Decorations

You can print just the Mill and top if you wish (See pics) or the whole thing wit the base. I only used supports for the screw holes in the Base but it might print fine withou it. No other supports are needed.

Motor / No Motor - The model is designed for a low RPM GA12-N20 motor it fits inside the top using the motor wedge for a tight fit. If you do not have / want the motor just use the No motor block with an M3 screw (I tested a 35mm one). Make sure you print the correct wing set.

Wings - There are 2 sizes of wings, normal for big printers and MINI for a 180mm print bed. Once you pick the correct size choose the correct type either for a motor or for the non-motor version.

Decorations - Not needed, but it makes it look much nicer, Windows are designed for a single layer on the bottom. Both doors and windows fit in their grooves (The window holes have edges that the widows sit on), most wont need any glue but if the fit is a bit loose or you want some peace of mind just glue it.

Fusion 360 files are attached for remixes, have fun and enjoy!

Colors I used:
Top and Base - Amolen wood Ebony
Mill - Amolen light wood
Wings - Amolen walnut
Doors and windows - Amolen mahagony (White base for window, matt black for knobs)