Sunlu S2 PTFE Adapter double connection
Remixed by
Copyright Claim
Sunlu S2 PTFE Adapter double connection
Remixed by
Boost
19
53
13
Print Profile(1)
0.2mm layer, 4 walls, 50% infill
Designer
35 min
1 plate
Boost
19
53
13
1
69
47
Released
Description
review of the sunlu s2 ptfe tube adapter
double connection for tangent wire exit both from the top and from the bottom. for the lower part the existing hole must be slightly enlarged by a few tenths of a mm
suitable for M10 quick connectors
The following parts are required.
1x PC4-01 Bowden connector
A piece of double-sided heat-resistant foam tape (i used 3M adesive).
Comment & Rating (13)
All
Print Profile
0.2mm layer, 4 walls, 50% infill
thank you. it works. only thing is that I have to figure out which glue is best for it. I tryed 2 glues but it not sticking.
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
just need to wait for the fittings to arrive!
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
awesome thanks
0
Reply
Boosted
great!
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Boosted
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
Print Profile
0.2mm layer, 4 walls, 50% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld