Sunlu S2 Dryer 10mm ventilation with hole
Copyright Claim
Sunlu S2 Dryer 10mm ventilation with hole
Boost
5
11
4
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
42 min
1 plate
Boost
5
11
4
0
19
9
Released
Description
A addon for the Sunlu S2 filament dryer.
A clip to open the box a little bit so that the humid air can leave the drying box more easily.
This clip opens the box 10mm and has a hole for extra ventilation.
In my other uploads you can find a 5mm and 15mm variant with a hole through it to decrease or increase the ventilation.
Or the 5mm clip without hole to have a little less ventilation but keeping the heat as much as possible inside.
These are the links to the other models:
Sunlu S2 Dryer 15mm ventilation with hole
Comment & Rating (4)
All
Don't these let humid air back in? I don't see the point.
The designer has replied
0
Reply
Thank you for your comment.
In the beginning when the relative humidity of the filament on the spool is on the high side the Sunlu drying will heat the moisture out of the filament. This makes sure that the moisture in the air will be pushed out of the dryer.
(Edited)0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld