Modular Lithophane Frame

The creation possibilities are endless with this modular Lithophane Frame

ONLY USES 8mm LED strips

Width & Height Informaiton:

Please when printing/creating lithophane use the following measurements:

Width or height minimum: 86mm Max 226mm in multiples of 20 

1. Use https://lithophanemaker.com/ to create the lithophane using the following parameters
   1. Resolution: Anything
   2. Width: See width and height Info
   3. Height: See width and height Info
   4. Depth: 3.75mm
   5. Base Height: 3mm
   6. Overhang Angle: Any
   7. Maximum Thickness: 3.0mm
   8. Minimum Thickness: Any
2. Print the correct parts depending on your image. Use inner frame connectors for the inside of the frame. Use outer frame connectors for the outside of the frame. Border connectors are for corners, 3 way and 4 way splits. Use the 3 Way dual sided if youd like to have 2 different sized images next to each other.
3. Connect each frame together and insert your lithophane panel. You might have to connect or disconnect some to get it to all come together. 
4. LED runners need to be in the max dimensions (If you have a 206 x 166 picture use the 206 or 166 LED strip runner.)
5. To add LED lights use the 8mm ONLY led lights by running them through the hole in the LED runner and across to the other side of the frame and through the hole again. As shown below