Milwaukee battery holder M18 - Dual holder
Copyright Claim
Milwaukee battery holder M18 - Dual holder
Boost
9
15
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
3.1 h
1 plate
Boost
9
15
5
0
71
36
Released
Description
ENG:
The Milwaukee battery holder M18 is a wall-mount battery holder with a safety device against accidental release. A slight slope from the wall allows easy removal of the battery. The holder can be attached to the wall in all directions.
CZ:
Milwaukee battery holder M18 je nástěnný držák baterie s pojistkou proti náhodnému uvolnění. Mírný sklon od zdi umožnuje snadné vyjmutí baterie. Držák lze připevnit na zeď všemi směry.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
incredible mounted in my van now
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Works awesome. Quick print and battery locks in just as it would in your impact. I would recommend using the suggested supports at the top where the battery does lock in. I did not choose to use any and the (4) overhangs got a bit squirrely as it's difficult to print in thin air.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld