This is a bracket to hold an LED channel light for the A1 / A1 Mini. It's in four parts:

1. The mount itself which has two 2.9mm through holes (for M3 screws) to attach things top and bottom (eg the light or maybe a camera bracket).
2. A small bracket that will take a 17mm x 14mm “deep” led channel held in by two M3 screws.
3. Top and bottom of modified version of the ESP 32 D1 Mini case by @briancmoses (this part is CC BY NC so you can't sell the ESP case). This also has two M3 screw holes, you will need countersink screws to ensure they clear the ESP Board.

I used a 144 LED/M strip and 30cm of LED channel (42 LED's) which will run from a 2.4A USB charger.

You can easily remix a bracket for whatever lights you prefer (eg cheap “under counter” lights from AMZN). If you make you own bracket you will need to adjust it by 30 degrees to get it level. I chose WLED becasue a) It's what I had to hand and b) if it's worth doing it's worth over doing! So mine is programmed in Home Assistant to go green when a print completes and red if a print fails.

Apart from the print you will need LED channel, LED strip, ESP32 D1 Mini and a USB power supply (or a light if you choice)

4 M3x8 and 2 M3x10 or 12 countersing machine screews.