x10 Can dispenser (A1 MINI Version)
Remixed by
Copyright Claim
x10 Can dispenser (A1 MINI Version)
Remixed by
Boost
7
32
5
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.9 h
4 plates
Boost
7
32
5
0
64
95
Released
Description
Fully ready to print on A1 mini, can hold up to x10 UK size pop cans. done it slightly smaller to fit the a1 mini bed. Works perfect.
Knock the speed up to sport on all parts to reduce print time.
This is based off the can dispenser on Thingiverse, full credit goes to original creartor - Can dispenser (12 cans, low filament) by CueBall909 - Thingiverse
Comment & Rating (5)
All
I can't speak for all countries, but in many European countries the "sleek cans" are used. The size is 146 x 58 mm.
As there is no other can dispenser for the A1 mini, I printed this one and then created 4 extensions using very simple methods. It's not professional, unfortunately I'm a noob in 3d printing and all the software required.
It works perfectly, just doesn't look as good as without these extensions.
0
Reply
Printed fine on A1 Mini. Definitely recommend running it on sport mode to speed things up.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld